COBRA TOOLOPERATOR’S SAFETY & OPERATING INSTRUCTION MANUALDANGERTHIS TOOL FOR USE BY LICENSED OPERATORS ONLY.READ AND OBEY ALL SAFETY AND OPERATIN
4. Hold the tool perpendicular (90°) to the work surface with both hands andpress firmly to fully depress the tool.Maintain firm downward pressure on
REFER TO PARTS SCHEMATIC FOR PROPER ASSEMBLY OF PARTS– Overdriving of fasteners – Excessive power – Change to the next lower power level load strip c
PARTS SCHEMATICPARTS SCHEMATIC12
PARTS LIST / MAINTENANCEPARTS LIST / MAINTENANCE13Always make sure the tool is not loaded before performing any service or repair andalways wear safet
DISASSEMBLY14DISASSEMBLYTOOL DISASSEMBLY1. Rotate the barrel retention clip off of thepawl using a flat blade screwdriver orthe point of a long faste
DISASSEMBLY15DISASSEMBLY 6. Slide the piston out of the rear barrelassembly and slide the guide out of thefront barrel. The tool is now disassembled
WARRANTYALL WARRANTIES OF THE PRODUCTS DESCRIBED HEREIN, EXPRESSEDOR IMPLIED, INCLUDING THE WARRANTY OF MERCHANTABILITY ANDFITNESS FOR PARTICULAR PURP
Just as no one can merely read a book about driving an automobile and then hope to drive one safely, no one should attempt to use any Ramset tool with
PreparationAcceptable Base MaterialsPowder actuated fastening is suitable foruse in the following base materials only:• Poured Concrete• Structural St
Loads & Load Selection Safety1. Always make a test fastening afterbeing sure that the base material is suitable for powder actuated fastening.Fail
Tool Handling Safety1. Always be sure tool is operatingproperly before attempting to use it. Follow the “Daily Function Check”shown to the right and d
FAILURE TO FOLLOWINSTRUCTIONS CANCAUSE INJURY TO THETOOL OPERATOR OR TO BYSTANDERS.Fastener Driving Safety1. Only use the tool for fastening into a su
FASTENERS / LOADSFASTENERS / LOADS7Your Ramset Cobra Tool uses only the Ramset fasteners and loads shown below or listed for the tool in the Product C
FASTENING APPLICATIONSYour Ramset tool can be used for a widerange of fastening needs in a variety of basematerials. Reading and follow these importan
TOOL OPERATIONDaily Function TestAlways check the tool first to make surethat it does not contain a strip load orfastener. Test the tool several times
Comments to this Manuals