search

RAMSET RAM 30 30 Specifications Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
    • Rated. / 5. Based on customer reviews
Page view 14
13
www.ramsetinc.com
RAMSET
RAM 30 UL
Dip Switch "C" 2; Not in use at this time.
Leave in the ‘Off’ position.
Dip Switch "C" 6; “OPEN DELAY”
One second delay on the opening of the gate.
Dip Switch "C" 5; “CLOSE DELAY”
One second delay on the closing of the gate.
DIP SWITCH "C"
Dip Switch "C" 1; “SECURE CLOSE”
Sw. Function:
OFF Normal Operation
ON When power is lost, then regained, control board
checks status of the gate. If open and safety
devices are cleared, gate will close automatically.
Dip Switch "C" 3; “RADIO CYCLE”
Sw. Function:
OFF Normal Operation - gate only opens and closes on
the limit switches. If the gate is in travel then it will
always open.
ON Cycle mode - gate opens and closes on the limit
switches, but if in travel, then it will stop with a first
command and reverse with a second command.
Dip Switch "C" 8; “SLAVE MODE” Master/Slave configuration
Sw. Function:
OFF Master mode - single gate operation. All peripheral
devices are to be connected to the master operator.
ON Slave mode - used to synchronize operation between
two gates. Commands are received from the master
through a 3-wire, shielded cable.
(Not provided with unit).
Dip Switch "C" 7; “LEFT / RIGHT”
Sw. Function:
OFF Left hand installations - All operators come factory
set for left hand operation.
ON Right hand installations - Reverses motor & limit
switches without moving any wires.
Dip Switch "C" 4; “ONE PASS”
Sw. Function:
OFF Normal Operation - fully opens and closes
ON One pass mode - The gate will open until “the revers-
ing loop” is initially activated and then cleared, the
gate will then close. If the “reversing loop” is then
activated again, before the gate is fully closed, the
gate will stop until the “reversing loop” is cleared, then
continue to close.
WARNING:
When installing or servicing an operator, make sure switch
"C" 1 is ‘Off’. If switch "C" 1 is ‘On’, the gate will move
when power is applied and severe injury may occur.
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Comments to this Manuals

No comments
Related products and manuals for Gate Opener RAMSET RAM 30 30
Gate Opener RAMSET RAM 5500 Instruction Manual   (24 pages)
Gate Opener RAMSET RAM 1000 Specifications   (26 pages)
  • AerPOS W.Tech Starlight-xpress Harken Viking spas
  • Altina Navigators Rosewill Networking cards RIDGID Power sanders JayBird Mobile device dock stations Nikon Uninterruptible power supplies (UPSs)
  • Acer Holo360 Lg BS254 Canon EOS Rebel T4i Moulinex BCB2 Pocketbook A 10 3G
  • Sony MEX-GS810BH User Manual Linksys SRW248G4 User Manual Bissell PROLITE MULTI CYCLONIC User Manual Acer XB270HU User Manual Yamaha MTX5 Owner's Manual