RAMSET Cobra Tool Operations Instructions download pdf (Page 9)

TOOL OPERATION

Daily Function Test

Always check the tool first to make sure

that it does not contain a strip load or

fastener. Test the tool several times by

depressing the muzzle bushing fully on a

hard surface and pulling the trigger. You

should hear an audible click as the firing pin

releases. Let up on the tool and check to be

sure that the barrel has opened to the semi-

open position.

OPERATING THE RAMSET

COBRA TOOL

1. After checking to be sure that the tool

is not loaded, point it in a safe direction

and be sure that the barrel is fully

extended and then close the tool to the

semi-closed position. This assures that

the piston is in position for the next

fastening. Use the spall guard every

time possible to minimize the risk of

being struck by flying debris.

2. With finger off the trigger, place the

fastener, point out, into the muzzle

end of the tool until the point end is

inside the muzzle. NEVER load a

fastener with your finger on the trigger.

DO NOT use excessive force when

inserting a fastener. STOP immediately

if excessive force is require, inspect

the barrel to find out why the fastener

is not entering the muzzle freely. DO

NOT continue loading unless the

problem is corrected.

3. With the tool pointed in a safe

direction and finger away from the

trigger, insert a load strip into the

bottom of the handle and push it in

until your finger is in firm contact with

the handle recess.

TOOL OPERATING INSTRUCTIONS

TOOL OPERATING INSTRUCTIONS

9

FULLY OPEN AND CLOSE TOOL TO THE

SEMI-CLOSED POSITION

INSERT FASTENER INTO THE MUZZLE END OF

THE TOOL WITH THE POINT OUT

INSERT LOAD STRIP INTO THE OPENING IN

THE BOTTOM OF THE HANDLE

PERFORM THE FUNCTION TEST WITH EMPTY,

UNLOADED TOOL

KEEP HANDS

AWAY FROM

MUZZZLE

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments