RAMSET RAM 30 30 Specifications download pdf (Page 24)

22

RAM 30-30

RAMSET

www.ramsetinc.com

TROUBLESHOOTING TABLE

CONDITION

NO LIGHTS ARE 'ON'.

GATE MOVES A COUPLE

OF FEET AND THEN

REVERSES.

"EXIT" L.E.D. IS ALWAYS

'ON'.

"REV LOOP" L.E.D.

ALWAYS 'ON'.

"RADIO" L.E.D. ALWAYS

'ON'.

GATE DOESN'T OPEN.

GATE DOESN'T CLOSE.

GATE DOESN'T CLOSE

AUTOMATICALLY.

GATE AUTOMATICALLY

OPENS, BUT DOESN'T

AUTOMATICALLY CLOSE.

RADIO/RECEIVER HAS NO

RANGE.

POSSIBLE CAUSES

1. Circuit breaker popped.

2. 1/2 amp. fuse blown.

3. Power supply damaged on

Control Board.

1. E.R.D. too sensitive.

1. Faulty accessory connected

to the "Exit".

1. Faulty accessory connected

to the "Rev Loop".

1. Stuck button on Transmitter

2. Faulty Receiver.

1. Radio L.E.D. 'On'.

2. 10 amp. fuse blown.

3. Opening accessory not func-

tioning.

1. No lights are 'On'.

2. Exit, Rev Loop, Radio L.E.D. 'On'.

3. 10 amp. fuse blown.

4. Thermal/overload button

popped on motor.

1. Dip switches "A" 1-3 are all

'Off'.

2. Dip switch not on all the way.

1. Motor direction wrong.

1. Signal blocked.

2. Area not suitable for type of

Receiver.

SOLUTION

1. Reset circuit breaker.

2. Replace 1/2 amp. fuse.

3. Return Control Board for repair.

1. A) for 1/2 hp motors: turn dip switch

"A" 4 'On'.

B) for 3/4 hp motors: turn dip switch

"B" 8 'On'.

1. Disconnect all accessories, including

plug-ins, using the "Exit" input.

If problem persist, contact Ramset.

1. Disconnect all accessories, including

plug-ins, using the "Rev Loop" input.

If problem persist, contact Ramset.

1. Check all transmitters.

2. Remove receiver.

If problem persist, contact Ramset.

1. See above symptoms/solutions.

2. Check/replace 10 amp. fuse.

3. Check/replace opening accessory.

1. See above symptoms/solutions.

2. See above symptoms/solutions.

3. Check/replace 10 amp. fuse.

4. Reset thermal/overload button on the

back of the motor.

1. Set dip switches "A" 1-3 for auto

close.

2. Turn off dip switches "A" 1-3, then

turn the appropriate switches back

'On'.

1. Turn on dip switch "C" 7 (left/right).

1. Make sure antenna is in proper posi-

tion & not shorted to chassis.

2. May need to change to long range

receiver.

1 2 ... 19 20 21 22 23 24 25 26

Comments to this Manuals

No comments